[TYPO3-calendar] new category handling

[Mario Matzulla]

Hi Stefan,

Am 11.01.13 10:02, schrieb Stefan Schreck:
> MARIO !
> this seem to work!
> Thank you.
>
> One drawback:
> If there is no related Event I get
>
> Calendar Base Error
> Message: Missing or wrong parameter. The event you are looking for could
> not be found.
> Note: Please verify your URL parameter: tx_cal_controller[uid]
>
> insteaed of empty output!
> Is it a misconfiguration on my side?

Well, if you try it with a minimal configuration (just the categoryMode 
and includeEventsInResult) does it show up too?
If so, please create a bugreport.

Regards,
Mario

> best
> stefan
>
> On 2013-01-10 20:31:08 +0000, Mario Matzulla said:
>
>> Hi Stefan,
>>
>> Am 10.01.13 20:43, schrieb stefan schreck:
>>> And does it need
>>>
>>> categoryMode = 3
>>
>> I'm using the view.categoryMode setting. In case of 1 and 3 I will
>> keep the setting.
>> So everything can be controlled via categorMode :)
>>
>> Regards,
>> Mario
>>
>>> ?
>>>
>>> thanks for your effort.
>>> because of your quick response we could - if it works - launch after the
>>> weekend.
>>> s
>>>
>>>
>>> On 2013-01-10 17:00:58 +0000, Mario Matzulla said:
>>>
>>>> Hi Stefan,
>>>>
>>>> Am 10.01.13 12:10, schrieb Stefan Schreck:
>>>>> and needless to say but the same setup works with cal ver. 1.4.3!
>>>>
>>>> yes, and that was the right clue: in the controller I hardcoded:
>>>> $this->conf['view.']['categoryMode'] = 1;
>>>>
>>>> I fixed it in rev69747 :)
>>>>
>>>> Regards,
>>>> Mario
>>>>
>>>>> stefan
>>>>>
>>>>> On 2013-01-10 10:46:34 +0000, Stefan Schreck said:
>>>>>
>>>>>> And even when I use parent categories like this:
>>>>>>
>>>>>> Event A
>>>>>> CAT Parent 1
>>>>>> Child CAT 1, 2, 3
>>>>>>
>>>>>> Event B
>>>>>> CAT 1
>>>>>>
>>>>>> Should Event A related to Event B via Child CAT 1 / CAT 1
>>>>>> Right?
>>>>>> It doesn't.
>>>>>> best
>>>>>> stefan
>>>>>>
>>>>>>
>>>>>> On 2013-01-09 19:36:18 +0000, idleX said:
>>>>>>
>>>>>>> NOPE
>>>>>>> as soon as there is a category which is NOT part of the current
>>>>>>> event
>>>>>>> the relation is gone.
>>>>>>>
>>>>>>> by the way the setting for
>>>>>>>
>>>>>>> categoryMode = 3
>>>>>>>
>>>>>>> could have been also set by the plugin itself and I tried that
>>>>>>> already.
>>>>>>> Uhhh.
>>>>>>> thx
>>>>>>> stefan
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>>> sorry, my fault. I meant:
>>>>>>>>
>>>>>>>> view.categoryMode = 3
>>>>>>>> and
>>>>>>>> view.event.event.includeEventsInResult = 1
>>>>>>>>
>>>>>>>> Regards,
>>>>>>>> Mario
>>>>>>>>>
>>>>>>>>> SAD, nogo.
>>>>>>>>> then it won't show any related events at all.
>>>>>>>>> best
>>>>>>>>> stefan
>
>