[TYPO3-doc] Share font

[François Suter]

Hi again,

> I will make a try (probably tomorrow) and come back with instructions
> for updating existing documentation.

Thanks for all your comments, here's version 2:

http://d.pr/kLSx

I also think that Share Bold is too heave for large titles. I have thus 
made it so in this version: globally all occurrences of Gillius n°2 (and 
I had missed a couple) are replaced by Share Regular, except for:

- the smaller titles (Heading 4 + 5) where it was indeed hard to tell 
apart from the body text. In this case I used Share Bold.
- in the table caption I switched to Vera Sans Mono, as it is a more 
technical information and Share looked out of place there.
- for the table of contents I switched to Baskervald as it didn't look 
good to have the whole TOC in Share.

My personal opinion is also that Share is not a very legible font, even 
when used just for headings. However it is our official font and it's 
proper that we should use it.

Vera Sans Mono definitely stays for code samples IMO.

Cheers

-- 

Francois Suter
Cobweb Development Sarl - http://www.cobweb.ch