[TYPO3-core] RFC #14719: Automatically create ENABLE_INSTALL_TOOL file when 1-2-3 Install Tool is used

[Steffen Kamper]

Hi,

Helmut Hummel schrieb:
> Hi,
> 
> On 16.06.10 23:26, Steffen Kamper wrote:
>> After some more thoughts and discussions with Jeff i think about
>> following solution:
>>
>> If no DB connection is configured, always
>> 1) create ENABLE_INSTALL_TOLL file
>> 2) force 1-2-3 mode for enter DB params
>> 3) forbid advanced mode. If you try with manual url, redirect to 1-2-3 mode
>>
>> This is very strict but makes sense: without db params you can't run
>> TYPO3, so no reason to configure advanced params.
>> This is absolutely safe, no security issues can raise.
> 
> I general this sounds good, but:
> 
> Finishing the 123 installer will configure the db connection in
> localconf.php, right? So you only need to finish the 123 mode steps to
> get full access to the install tool.
> 
> Or did I get it wrong?
> 
> 

yes, but you never get to step 2 without correct data, so you are bound 
to one form. After Step 2 you can enter advanced mode (again)

vg Steffen