[TYPO3-english] TYPO3 TS userlisting: using AVG, SUM etc in select
Bert Hiddink [BENDOO e-work solutions]
hiddink at bendoo.nl
Sun Dec 8 10:59:21 CET 2013
Hello Jigal,
Thanks for the tip, I'll try that and report back!
Regards,
Bert
On 07-12-13 16:44, Jigal van Hemert wrote:
> Hi,
>
> On 6-12-2013 14:22, Bert Hiddink [BENDOO e-work solutions] wrote:
>> Now I have the snippet as shown below...
>> However, while the "20"-block renders correctly, the "10"-block does not
>> render any output.
>
> On trick to debug the actual query that was generated is:
> - set in Install Tool that failing queries are listed (probably also
> useful to list your IP-address in the devIpMask)
> - make a deliberate syntax error in the query (e.g. remove first
> character of table name)
>
> Now the query will fail and you'll see the full query above the page
> output. You can use this query (with the corrected table name) in a
> database tool (Adminer, PhpMyAdmin, etc.) to test further.
>
More information about the TYPO3-english
mailing list